PHYSICO-MECHANICAL AND FILM-FORMING PROPERTIES OF CARBOXYMETHYL CORN STARCH BUTYRATE

Authors

  • Ornanong S. Kittipongpatana Department of Pharmaceutical Sciences, Faculty of Pharmacy, Chiang Mai University, Chiang mai, Thailand
  • Nisit Kittipongpatana Chiang Mai University

Keywords:

Corn starch, Carboxy methylation, Butyrylation, Hydrophobicity, Film-former, Pharmaceutical excipient

Abstract

Objective: This study aims to prepare a new hydrophobic, water-soluble modified corn starch via sequential butyrylation and carboxymethylation and to evaluate its physico-mechanical and film-forming properties.

Methods: Butyrylation was carried out in an aqueous suspension using 25%w/w butyric anhydride to yield corn starch butyrate (CSB). CSB was further reacted with chloroacetic acid in alkaline methanolic solvent to carboxymethyl corn starch butyrate (CMCSB). Following the determination of the degrees of carboxymethyl substitution (DS-Cm) and butyrylation (DS-Bu), CMCSB was subjected to analyses by scanning electron microscopic (SEM), X-ray diffraction (XRD), solubility, viscosity, free swelling capacity (FSC), moisture sorption, film formation and water vapor transmission rate (WVTR).

Results: DS-Cm of CMCSB was 0.24, while DS-Bu was 0.09. SEM images revealed significant granules fusion and surface roughness. XRD showed a decrease in the degree of crystallinity. CMCSB was soluble in water, with a three times lower viscosity than that of CMCS. Initial FSC of CMCSB was slightly lower than that of CMCS, but gradually increased to a higher FSC after 30 min. A significant drop of moisture sorption from 20% in CMCS to 11% in CMCSB was observed at 93% relative humidity. CMCSB formed intact film with slightly better flexibility than that of CMCS. WVTR of CMCSB was decreased by a maximum of 4.9% compared to CS, and 10.2% compared to CMCS.

Conclusion: The introduction of the butyrate group increased the hydrophobicity of the modified starch, altered some of the physic-mechanical properties, and enhanced the barrier property of the modified starch film.

Downloads

Download data is not yet available.

Author Biography

Ornanong S. Kittipongpatana, Department of Pharmaceutical Sciences, Faculty of Pharmacy, Chiang Mai University, Chiang mai, Thailand

Department of Pharmaceutical Sciences

Associate Professor

References

Dias AB, Müller CMO, Larotonda FDS, Laurindo JB. Biodegradable films based on rice starch and rice flour. J Cereal Sci 2010; 51:213-9.

Krogar K, Antikainen O, Heinamaki J, Laitinen N, Yliruusi J. Tablet film-coating with amylase-rich maize starch. Eur J Pharm Sci 2002; 17:23-30.

Simsek S, Ovando-Martinez M, Marefati A, SjÓ§Ó§ M, Rayner M. Chemical composition, digestibility and emulsification properties of octenyl succinic esters of various starches. Food Res Int 2015; 75:41-9.

Saboktakin MR, Maharramov A, Ramazanov MA. Modification of carboxymethyl starch as nano carriers for oral drug delivery. Nature Sci 2007; 5:30-6.

Yang BY, Montgomery R. Preparation and physical properties of starch mixed esters. Starch-Stärke 2008; 60:146-58.

Kittipongpatana OS, Burapadaja S, Kittipongpatana N. Carboxymethyl mungbean starch as a new pharmaceutical gelling agent for topical preparation, Drug Dev Ind Pharm 2009; 35:34-42.

Kittipongpatana OS, Chaichanasak N, Kanchongkittipoan S, Panturat A, Tehkhunmark T, Kittipongpatana N. An aqueous film-coating formulation based on sodium carboxymethyl mungbean starch. Starch-Stärke 2006; 58: 587-9.

Tehkhunmag T, Kittipongpatana N, Malisuwan S, Watanageebudtra S, Kittipongpatana OS. Preparation, physicochemical and film-forming properties of carboxymethyl/ hydroxypropyl dual-modified corn starches, CMU J Nat Sci 2008; 7:219-30.

Mazíková V, Sroková I, Ebringerová A. Solvent-free synthesis and properties of carboxymethyl starch fatty acid ester derivatives. Chem Pap 2009; 63: 71-6.

Takahashi K, Ogata A, Yang WH, Hattori M. Increased hydrophobicity of carboxymethyl starch film by conjugation with zein. Biosci Biotechnol Biochem 2002; 66:1276-80.

Rahim A, Haryadi, Cahyanto MN, Pranoto Y. Characteristics of butyrylated arenga starch prepared at different reaction time and butyric anhydride concentration. Int Food Res J 2012; 19:1655-60.

Tupa M, Maldonado L, Vazquez A, Foresti ML. Simple organocatalytic route for the synthesis of starch esters. Carbohyd Polym 2013; 98:349-57.

Jerachaimongkol S, Chonhenchob V, Naivikul O, Poovarodom N. Modification of cassava starch by esterification and properties of cassava starch ester films. Kasetsart J Nat Sci 2006; 40:148-51.

Kittipongpatana OS, Sirithunyalug J, Laenger R. Preparation and physicochemical properties of sodium carboxymethyl mungbean starches. Carbohyd Polym 2006; 63:105-12.

HeB C, Hartmann B, Lechner MD, Nierling W, Seidel C, Kulicke WM. Influence of soluble polymer residues in crosslinked carboxymethyl starch on some physical properties of its hydrogels. Starch-Stärke 2007; 59:425-9.

Rahim A, Haryadi, Cahyanto MN, Pranoto Y. Structure and functional properties of resistant starch from butyrylated arenga starches. Afr J Food Sci 2012; 6:335-43.

Gao Y, Wang L, Yue X, Xiong G, Wu W, Qiao Y, Liao L. Physicochemical properties of lipase-catalyzed laurylation of corn starch. Starch-Stärke 2014; 66:450-6.

Garg S, Jana AK. Characterization and evaluation of acylated starch with different acyl groups and degrees of substitution. Carbohyd Polym 2011; 83:1623-30.

Cho KY, Lim ST. Preparation and properties of benzyl corn starches. Starch-Stärke 1998; 50:250-7.

Liu TY, Chen SY, Lin YL, Liu DM. Synthesis and characterization of amphiphatic carboxymethyl-hexanoyl chitosan hydrogel: water retention ability and drug encapsulation. Langmuir 2006; 22: 9740-5.

Published

01-01-2016

How to Cite

Kittipongpatana, O. S., and N. Kittipongpatana. “PHYSICO-MECHANICAL AND FILM-FORMING PROPERTIES OF CARBOXYMETHYL CORN STARCH BUTYRATE”. International Journal of Pharmacy and Pharmaceutical Sciences, vol. 8, no. 1, Jan. 2016, pp. 302-6, https://mail.innovareacademics.in/journals/index.php/ijpps/article/view/9192.

Issue

Section

Original Article(s)